F-Series power amplifiers are designed to live sound reinforcement, touring systems or fixed installation. As toroidal power transformer power amplifiers, they are top standard quality in current market. They are the ideal choice when high headroom and low distortion are needed, especially when reproducing the dynamic range and clarity of today digital recordings.
Key Feature:
• 2/3U high, heavy duty steel chassis
• Modular construction for easy servicing
• Symmetrical layout for even weight distribution
• High efficiency toroidal power transformer
• Oversized, high energy, linear power supply
• 3 steps, Class H Audio topology
• Stereo, parallel or bridged operation
• Twin balanced inputs (Neutrik® XLR connectors)
• Dual Speakon® and Binding posts outputs
• High quality components used throughout
• Dual, continuously variable speed fans
• Efficient two sides cooling, the efficiency is better than back to front cooling
• Active, signal, protect and critical indicators
• Duraluminium, 8mm thick front-panel
• Unobtrusive carrying handles
• Voltage Gain: 35 or 40 dB
F3500 Power Amplifier |
8ΩStereo Power(RMS) | 2×1050W |
4ΩStereo Power(RMS) | 2×1600W |
Frequency Response(+o/-0.3dB,1W/8Ω) | 20Hz-20kHz,-3dB@135kHz |
Power Bandwidth (rated power at 4Ω 1%THD+N) | 20Hz-20kHz, -.1.1dB/+0dB |
TourClass Protection | ACL,IGM, AutoRamp, short circuit, DC voltage, turn-on/off transient, current inrush, sub/ultrasonic input |
THD+N (1kHz 1W ) | <0.05% |
SMPTE IMD (rated power. 60 Hz & 7kHz) | <0.01% |
Damping Factor ( 1KHz) | 248 |
Input CMRR (1kHz) | >-60dB |
Voltage Gain (rated power @ 8Ω) | X40dB |
Input Sensitivity (rated power at 8Ω) | 0.8V |
Input Impedance (balanced/unbalanced) | 20KΩ/10KΩ |
S/N Ratio ("A"weighted, full power at 4Ω) | 96.5dB |
Crosstalk ("A"weighted, full power@4Ω) | >-65dB |
Class | 3 Step H |
Input Connectors (per channel) | Female XLR (pin 2+, configurable for pin 3+). TRS (tip+) |
Output Connectors (per channel) | 5-way binding posts or Speakon connectors (market dependent) |
Supply Power | 4158W |
Power Supply (factory configured) | AC220V/230V,50-60Hz |
Cooling | Two side panel variable speed DC fans, better than conventional cooling |
Controls | Front panel: 2 attenuators, power switch; Rear panel: signal ground lift & mode switches. |
LED Indicators (per channel) | Signal, Protect, Active, Critical |
Construction | Steel chassis, 16 gauge . Casting Aluminum front panel. |
Dimensions (H×W×D) | 132×483×480mm (3U) |
Net Weight | 33.5kg |
Gross Weight | 34.35kg |
